Hi, Crystal Office community,
it's just a few days ago that I had my maple professional v6.1 update from my 5.x version (by the way: Windows XP Home SP2). Now it happens - irregulary - that pressing CRTL-S or clicking on "save" in the file menu causes the programme to stop and termination is only possible by using the task manager.
There seem to be no problems on my system (hardware ok, no viruses etc.) and other applications work fine while accessing the hard drives. A new installation of Maple didn't help.
What's about that?
Any ideas?
Thanks in advance
Klaus
Maple v6.1 crashes irregulary
Excuse my late reaction, but I caught a terrible flu which drove me down so that there were now energies left for computing affairs. But now:
Thank you very much for the described solution, but it didn't help. I exported the mpl-file the mentioned way and then started maple with the new (and now smaller) data file. But again the programme hangs after clicking "save" or pressing CRTL-S.
Any other ideas?
Best wishes
Klaus
Thank you very much for the described solution, but it didn't help. I exported the mpl-file the mentioned way and then started maple with the new (and now smaller) data file. But again the programme hangs after clicking "save" or pressing CRTL-S.
Any other ideas?
Best wishes
Klaus
I can say, that I've created mpl-files, where the described problem doesn't appear. The problematic file differs in one point from the others because of a really big table residing in it and lots of hyperlinks in the cells of the mentioned table. I want to use this mpl-file to administer a great amount of documents.
Do we get a little nearer to the problem?
Thank you very much for your efforts!
Sincerly
klaus
Do we get a little nearer to the problem?
Thank you very much for your efforts!
Sincerly
klaus
I think we should take a look at this file to find the possible reason. Could you please send it to support@crystaloffice.com ?
Hello, again,
thank you for your efforts, but there's no more help needed! As I told you, exporting the mpl-file (as you suggested) couldn't solve the problem. So I removed my big table with lots of hyperlinks, exported the file, reopened it and built that table again, et viola: It works! (For now!)
I'll post again when bad things happen!
Best wishes
Klaus
thank you for your efforts, but there's no more help needed! As I told you, exporting the mpl-file (as you suggested) couldn't solve the problem. So I removed my big table with lots of hyperlinks, exported the file, reopened it and built that table again, et viola: It works! (For now!)
I'll post again when bad things happen!
Best wishes
Klaus
Who is online
Users browsing this forum: No registered users and 2 guests