Hello,
I want to try out the Winlock Remote Administrator and its feature set. For the "scan for active clients" feature in Winlock Remote Administrator :
1.) Which port should be open on both the client and server- in order to connect?
2.) Which protocol (e.g RDP) and packet type (e.g UDP or TCP) will it use?
3.) Should port forwarding be used in a network that has more than one subnet?
4.) Will the "scan for active clients" work on a Vlan?
5.) Is there any other client configuration that should be configured - other than "Enable" Winlock Remote Administrator on Winlock Professional?
Your input will be greatly appreciated
how to use the "scan for active clients" feature in winlock
Re: how to use the "scan for active clients" feature in winl
Hello,
Port that was selected in WinLock client under General->Remote administraton. And, port 4000.Which port should be open on both the client and server- in order to connect?
A proprietary protocol via UDP.Which protocol (e.g RDP) and packet type (e.g UDP or TCP) will it use?
It should work as well.Will the "scan for active clients" work on a Vlan?
No. You should enable remote administration and, optionally change port value (2000 by default).Is there any other client configuration that should be configured - other than "Enable" Winlock Remote Administrator on Winlock Professional?
Re: how to use the "scan for active clients" feature in winl
Hello Support,
Thank you for your reply. I just want to clarify that - I need too set the Winlock Client port (not a server) to port 400?
Thank you for your reply. I just want to clarify that - I need too set the Winlock Client port (not a server) to port 400?
Re: how to use the "scan for active clients" feature in winl
No. You may set any port you wish but not 4000.
Port value in WRA and client should be the same.
Port value in WRA and client should be the same.
Re: how to use the "scan for active clients" feature in winl
Do I need to have a broadcast id configured? Is this suppose too be a standard IPV4 Broadcast/multicast ip (e.g. 234.230.200.232), or should be the same IP address as the computer with the Winlock Administrator installed?
Re: how to use the "scan for active clients" feature in winl
This should be a standard broadcast address.
Who is online
Users browsing this forum: No registered users and 8 guests